6.3.
Trimmer blade sharpening
When sharpening the blade you MUST wear safety gloves.
6.3.1. Remove the cutting blade from the shield. Remove the blade by undoing the 3 self-
tapping screws (put in a safe place). Place the blade firmly into a vice.
6.3.2. Sharpen blade using a suitable flat file. You MUST maintain the blades original cutting
angle.
6.3.3. Reverse process to refit blade.
6.4.
Storage.
If you do not follow these steps, deposit
may arise in the carburetor. This will cause
starting difficulties and may cause
permanent damage.
6.4.1. Perform all the general
maintenance that the maintenance section
of your ‘User Manual’ is recommended.
6.4.2. Clean the outside of the machine,
drive axle, shield and nylon cutting head.
6.4.3. Remove all fuel from the fuel tank.
6.4.4. After all the fuel has been removed
from the fuel tank. Start the engine. Allow
the engine to run in idle until engine stops
alone. This allows the fuel to be removed
from the carburetor.
6.4.5. Allow the engine to cool down for
about five minutes.
6.4.6. Remove the spark plug and pour
1 teaspoon of clean oil into the
combustion chamber. Slowly pull the
starter rope several times to coat internal
components. Replace the spark plug.
6.4.7. Store the machine in a cool, dry
place away from any source of ignition
such as an oil burner, water heater etc.
6.5. Transporting the machine.
6.5.1. When transporting the machine
make sure that no fuel is allowed to leak
out.
6.5.2. DO NOT allow the trimmer/brush
cutter come into contact with persons,
animals and property.
Cord cutter blade
3 x self-tapping
Fixing screws
Cord cutter blade
Page 30
Rev 3 - September 2016
Summary of Contents for HYBC5200
