Hyundai HYCH1500E-2, User Manual

26

6.80  

Work area.

6.81 

Thoroughly inspect the area to be worked, keep the working area clean and free of debris to 
prevent tripping. Operate on flat level ground.

6.82 

NEVER place any part of your body where it would be in danger if movement should occur 
during assembly, installation, operation, maintenance, repairing or moving.

6.83 

Keep all bystanders, children and pets at least 23m (75 feet) away.  If you are approached, 
stop the unit immediately.

6.84 

The operator or user is responsible for preventing accidents or hazards occurring to other 
people, their property and themselves.

6.85 

Start the engine carefully according to instructions.

6.86 

Before starting the wood chipper, make sure the feed hopper and cutting housing are empty 
and free of all debris.

6.87 

 NEVER place your hands, feet, or any part of your body in the chipper hopper, discharge  
opening, or near or under any moving part while the machine is running. Keep area of
discharge clear of people, animals, buildings, glass, or anything else that will obstruct clear  
discharge, causing injury or damage. Wind can also change discharge direction, so be aware. 
If it becomes necessary to push materials to the chipper hopper, use a small diameter stick,  
not your hands.

6.88 

NEVER allow an accumulation of processed material to build up in the discharge area as this 
will prevent proper discharge and can result in kickback from the chipper hopper. 

6.89 

Keep your face and body back from the chipper hopper and discharge chute to avoid
accidental bounce back of any material. 

6.A

NEVER reach with your hands inside the feed hopper past the rubber flap while operating 
the 

machine.

6.B

NEVER attempt to unclog either the feed hopper or discharge chute while the engine is
running. Immediately shut off the engine. Allow the cutting disk to come to a complete stop.  
Remove the clogged material. Inspect for damage and check for any loose parts for repair or 
replacement.

6.C

Whenever you leave the operating position or if you have to remove processed material,
leaves or debris from the machine, You MUST always shut down the engine, disconnect    
spark plug HT from the spark plug to prevent accidental starting,and wait for all moving parts 
to come to a complete stop.

6.D

DO NOT tilt the machine while the engine is running.

6.E

ALWAYS stop the engine before moving the machine.

6.F

ALWAYS make sure that the engine is switched off and that the cutting disk and engine are 
at a complete standstill and the belt drive is disengaged before opening the cutting disk
housing. 

6.G

You MUST keep all combustible materials and substances away from the engine when it is 
hot.

6.H

NEVER cover the machine while the muffler is still hot.