Hyundai HYCH1500E-2, User Manual

39

Issue

Possible causes

Possible corrective actions

STARTING DIFFICULTY
NORMAL SPARK
ISSUE WITH FUEL SYSTEM

Poor fuel supply.
1. No fuel in fuel system, fuel tap
closed.
2. Fuel cap air vent blocked.
3. Fuel tap blocked.

Fuel supply normal.
4. Dirty or stale fuel.
5. Water in fuel.
6. Incorrect fuel.

Poor fuel supply.
1. Fill with fuel – open fuel tap.
2. Clear blocked air vent.
3. Clear blockage.

Fuel supply normal.
4, 5 & 6. Clear fuel from system and 
refill with fresh fuel.

STARTING DIFFICULTY 
NORMAL FUEL
ISSUE HT LEAD/SPARK PLUG

Normal spark from HT lead.
1. Carbon build up on spark plug.
2. Electrodes badly burnt/damaged.
3. Incorrect spark plug gap.

No spark at HT lead.
4. HT lead damaged.
5. Ignition coil damaged.
6. Gap between ignition coil and
flywheel to big.

Normal spark from HT lead.
1. Clean carbon build up.
2. Replace spark plug.
3. Adjust the spark plug gap.

No spark at HT lead.
4. Replace HT lead.
5. Replace Ignition coil.
6. Adjust gap.

STARTING DIFFICULTY
(ELECTRIC)

Battery connection.
1. Loose or incorrect battery
connections.
2. Battery not charged.

Battery connection.
1. Check polarity and tighten
connections.
2. Remove battery from machine and
recharge.

MACHINE’S WHEELS TRACK LEFT 
OR RIGHT WHILE BEING TOWED

1. Low tyre pressures.

1. Inflate tyres.

THE SHREDDER DOES NOT 
SHRED PROPERLY. THE WOOD IS 
NOT PULLED INTO THE MACHINE 
BY ITSELF.
THE CHIPS DO NOT HAVE THE 
SAME SIZE.

1. The blades are worn too much.
2. The diameter of the branches
inserted into the machine are larger
than 100 mm for HYCH1500E-2 or
70mm for HYCH7070[E]-2
3. The gap between the fixed blade
and the counter-blade is too large,
the correct gap is ½ mm

1. Change or sharpen the blades and
counter-blade.
Note that the blades are sharpened
on both edges so they can be re-
versed.
2. Shut the engine off and remove the
branch that is too thick.
3. Adjust the gap between the blade
and the counter-blade in the slots

THE ENGINE WILL NOT START OR 
TURN BECAUSE THE ROTOR IS 
JAMMED.

1. The diameter of branches is too
big. There are unacceptable materials
such as stones or metal in the input
tube. A length of branch remains in
the rotor after the engine was last
stopped.

Shut off the engine, remove the spark 
plug cap. NEVER under any circum-
stances use your hands to remove 
stuck wood.
Reduce size of wood to 100 mm for 
HYCH1500E-2 or 70mm for HY-
CH7070[E]-2

or less.

Use a piece of wood to turn the rotor 
to remove the material from the rotor 
and input tube. If necessary, remove 
the cap of the bearing housing and 
rotate the rotor axle with a spanner.
If necessary, remove the input or out-
put tube to get access to the rotor.
Check the sharpness of all blades, 
have them sharpened or replace as 
required.
Make sure all blade bolts are properly 
tightened.