12
2.4
Attach the front support leg to the frame.
2.5
Slide the front support leg into the mounting bracket on the log splitter frame
and make sure the holes in the support leg and the holes in the frame line up.
2.6
Slide an M10x75 bolt through the top mounting hole, through the support leg and out of
the other side.
Secure in place with an M10 nut but leave just enough slack for the leg to move freely.
2.7
Slide the locking pin through the bottom mounting hole in the frame, through the
support leg and out the other side.
Secure in place using the P clip.
2.8
To raise or lower the leg, remove the P clip and slide the locking pin in or out depending
on whether you need to raise or lower the leg.
1. Support Leg 2. Locking Pin 3. M10x75 Bolt 4. P Clip 5. M10 Nut
5
4
3
2
1
