Hyundai HYU WS 1819, Instruction Manual

EN - 20

FIRST OPERATION

Install batteries in the sensor first!

First of all install batteries in proper direction according to the (+) and (–) poles.

As default, the sensor is set to channel 1 and the display is set to degrees of Celsius. Channel 

switching is necessary only when additional channels are in use.

Do not close the battery compartment cover yet.

Now insert the batteries in the receiver station (main unit).

Open the battery compartment cover on the back and insert the batteries according to the il

-

lustration in proper direction according to the (+) and (–) poles.

Place the main unit and sensor one beside another in the place free of any interference.

Now the synchronization process will start, which may take several minutes.

The outdoor temperature and the selected channel number will appear in the display’s upper 

section. Now the connection between the main unit and the sensor is established.

If any unexpected problems occur in establishing the connection between the main unit and the 

sensor, press the left white button (Tx) next to the channel setup under the battery compartment 

cover of the sensor. This may help establishing the connection between the main unit and the 

sensor manually.

When closing the sensor’s battery compartment please ensure that the silicone ring is exactly in 

the guiding rail to ensure the sensor to be waterproof.

The radio alarm clock simultaneously seeks the DCF radio signal to set time and it will adjust 

the clock absolutely automatically.

Also this procedure may take several minutes. Ensure that during this procedure the unit is not 

exposed to any harmful interference, for example from TV sets, computers or PC monitors. The 

signal is difficult to receive in basement premises or in concrete/steel buildings. In such a case, 

the problem may be solved by placing the alarm clock next to a window. Please note that the 

radio signal can only be received within about 1 500 km from Frankfurt am Main!

If the alarm clock does not receive the signal within 7 – 8 minutes, interrupt the scanning pro

-

cedure and the radio tower symbol will go off. Place the unit at a location without interferences 

and repeat the procedure by pressing and holding the “∙∙” button for 3 seconds. The radio tower 

symbol will start blinking again.

After successful synchronisation, the radio tower symbol will light up (without blinking). Now the 

time shown by the clock is set.

Manual time adjustment

When it is not possible to receive the radio signal upon putting the unit into operation, you may 

set the time and date manually.

Press the “MODE” button and hold it until the YEAR indicator starts blinking on the display. Now 

adjust the year using the arrow buttons (up or down) and confirm by the “MODE” button. Then 

the MONTH indicator starts blinking. Set the month using the arrow buttons and confirm by the 

“MODE” button. Apply the same procedure in adjusting the date and weekday language (GE 

= German, DA = Danish, NE = Dutch, ES = Spanish, IT = Italian, FR = French, EN = English), 

adjusting the displayed 12/24hour format, adjusting the time zone (usually 00; this item is to be 

changed if you get in a different time zone, for example during holiday) and adjusting the hours 

and minutes.