Hyundai HYU WS 1819, Instruction Manual

EN - 22

Battery status indicator

The battery status indicator will appear on the display once the battery level is critical. A battery 

symbol will appear next to the indoor temperature figure with the charging indicator for the main 

unit. The same symbol for the respective displayed sensor will appear beside the outdoor tem

-

perature figure. If necessary, replace the battery and proceed as when you put the unit into

operation for the first time.

Temperature alarm

The temperature alarm will switch on when the set outdoor temperature is exceeded or not 

reached according to your preference. To set the temperature alarm, please first set the number 

of the sensor, for which the alarm is to be activated – when only one sensor is used, the sensor 

number is already displayed. Now hold the “ALARM” button pressed for 3 seconds and set the 

desired limit values by the arrow buttons. Confirm always by short press of the “ALARM” button.

Alarm is then activated by short press of the “ALARM” button. A symbol with arrows (up/down) 

will appear on the display below the “Channel” box. The alarm may be deactivated by short 

press of the “ALARM” button and the symbol disappears.

Alarm

Setting the alarm time

Press and hold the “ALARM” button: “AL” will appear in the display and the hours figure will 

be blinking. Adjust the desired value by the arrow buttons and confirm by the “ALARM” button. 

Then the minutes figure will start blinking – adjust the desired value by arrow buttons and con

-

firm by the “ALARM” button. Now the alarm time is set.

Activating the alarm

Press shortly the “ALARM” button – a bell symbol appears on the display and the alarm func

-

tion is activated. To disable alarm, press the ALARM” button shortly again; the bell symbol will 

disappear.

Snooze alarm

If you activate the SNOOZE ALARM function by the “SNOOZE” button, the alarm will sound 

every 5 minutes.

To mount the unit on the wall

, use the opening on the cover back side.

Outdoor sensor installation

 – please adhere to the following:

Do not place the sensor under direct sunshine, but in a shadowy place. 

Select a place where the sensor is not directly exposed to rain.

The sensor must be in contact with the main unit, the maximum operation range is 30 m. To 

hang the sensor, use the opening in the cover; to adjust it, move the stand on the back side 

down in the arrow direction and the pull it out.

Instructions for waste disposal and for environment protection

Batteries

Do not throw batteries in household waste!

Each consumer is legally responsible to dispose batteries in a proper way!

The batteries may not get in contact with children (there is a danger of swallowing them), thrown 

in fire, short-circuited or disassembled. Otherwise the batteries may leak and damage the unit.

If battery leakage is imminent, remove the battery immediately to prevent damaging the unit.

Avoid contact with skin, eyes and mucosa. When you touch the acid leaking from the battery, 

rinse the affected spot with sufficient volume of water and/or see a doctor!