EN - 10
PASSWORD SETUP PAGE
Password mode
: Set password mode on/off. If set to off, change parental level will not check
password.
Password
: select the menu password change page.
OLD PASSWORD
: Enter the OLD password, (Factory setting is 1369), and the cursor will jump
automatically to NEW PASSWORD.
NEW PASSWORD
: Enter the NEW password. Enter 4 digits from the remote control unit
numeric buttons, and the cursor will automatically jump to CONFIRM PASSWORD.
CONFIRM PASSWORD
: Confirm the NEW password by entering it again. If the confirmation
is incorrect, the cursor will stay in this column. After entering, the correct new password again,
the cursor will jump automatically to OK.
OK
: When cursor is on this button, press ENTER key to confirm setting.
Note
: If the password has been changed, the parentaland disc lock code will also be changed.
The default password(1369) is always active even the password has been changed.
PARAMETERS AND SPECIFICATIONS
ELECTRONICAL PARAMETERS
Item
Standard requirement
Power requirements
: AC 100 – 240 V, 50/60 Hz
Power consumption
: < 10 W
Operating humidity
: 5 % to 90 %
Output
VIDEO OUT
: 1 Vp-p (75 Ω)
AUDIO OUT
: 1.2 Vrms (1 KHz, 0 dB)
