7-58
Apply grease to the O-ring (2-26) and the
pin (2-25), then assemble them in the
cover (2-21).
Press-fit the ball bearing (2-22).
2-26
2-22
2-25
2-21
§æ
R35Z77SM04
Assemble the spring seat (2-19) and the
disc spring assembly (2-18) in the correct
direction.
2-15
2-19
2-18
2-18
R35Z77SM08
Υ
2-18
2-18
2-19
Apply grease to the O-ring (2-20) and
assemble it in the case (2-1).
Check to see if the pin (2-25) can be
assembled in the brake piston and case
hole. If not, remove the brake piston (2-
15) and re-orient it, then reassemble.
Assemble the pin (2-25) while being
attached on the cover.
2-20
2-25
R35Z77SM39
§
ö
Install the pin (2-23), then install the valve
plate (2-24).
To prevent it from falling, apply grease to
the back side.
2-23
2-24
§
R35Z77SM03
