STEERING WHEEL / STALK / PANEL
9
EMERGENCY OVERRIDE PROCEDURE
STEERING WHEEL / STALK / PANEL
SYSTEM MAINTENANCE
Emergency Override Procedure
Use this procedure if your remote control transmitter is lost or fails to function
to disarm the security system and start your vehicle.
1. Use your key to enter the vehicle. The alarm will sound after the door
is opened.
2. Insert your key into the ignition and turn it to the ON position.
3. Press the override/programming button secured to the remote start
wire harness above the driver’s kick panel. The vehicle alarm will
stop sounding and the vehicle will be able to be started with the key.
Changing the Remote Control Transmitter Batteries
The (2) 3-volt lithium batteries (Model CR2016) supplied in your remote control
transmitter should last approximately three years, depending on usage. When the
batteries begin to weaken, you will notice a decrease in range or the distance from
the vehicle that your remote control will operate.
Follow the instructions below to change the remote control batteries.
1. Insert the edge of a coin into the slot on the bottom of the remote control.
Twist
the coin to pry the remote control halves apart.
2. Remove the old batteries and replace with new ones. Be sure to observe the
(+) and (-) sign when inserting the new batteries. The (+) sign must face
upward on both batteries.
3. Carefully snap the case halves back together, then test the remote control.
(+) Sign must
Face Upwards
on Both
Batteries
Disarm Button
Recycle or dispose of the old batteries according to your local laws or regulations.
