Hyundai RT409, User Manual

EN - 30

IMPORTANT NOTES

Since digital circuitry may cause interference to other radio or television tuners nearby, switch this 

unit off when not in use or move it away from the affected radio/television tuner.

NOTE: This digital apparatus does not exceed the Class B limits for radio noise emissions from 

digital apparatus as set out in the Radio Interference Regulations of Industry Canada. These limits 

are designed to provide reasonable protection against harmful interference in a residential installa-

tion. This equipment generates, uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio communica-

tions. However, there is no guarantee that interference will not occur in a particular installation. If 

this equipment does cause harmful interference to radio or television operation (which can be 

determined by turning the equipment off), the user is encouraged to try to correct the interference 

by one or more of the following measures:

-  Reorient or relocate the receiving antenna.

-  Increase the separation between the equipment and receiver.

-  Connect the equipment into an outlet on a circuit different from that to which the receiver is con

-

nected.

-  Consult the dealer or an experienced radio / TV technician for help.

FCC INIFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates, uses, and can 

radiate radio frequency energy and, if not installed and used in accordance with the instructions, 

may causes harmful interference to radio communications. However, there is no guarantee that 

interference will not occur in a particular installation. If this equipment does cause harmful interfe-

rence to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following measu-

res:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two con-

ditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause 

undesired operation.

PREPARATION FOR USE

UNPACKING AND SET UP

●  Carefully remove the unit from the display carton and remove all packing material from the unit.

●  Unwind the AC power cord and extend it to its full length.

●  Unwind the FM Antenna wire and extend it to its full length.

●  Place the unit on a stable, level surface, convenient to an AC outlet, out of Direct sunlight, and 

away from sources of excess heat, dust, moisture, humidity or strong magnetic fields.,

●  Raise the lid to expose the phonograph. The phonograph has been secured for shipment with 

  a transit screw. Use a coin or screwdriver to turn the transit screw clockwise. This will allow  the 

turntable to float .