Genuine Accessories
A.
Make sure the steering column is fully extended / tilted up and locked in place before installing the two (2) wire ties at the Steering Column as
shown.
B. Make sure the Remote Start Harness is routed as shown.
C. Using two (2) Wire Ties, secure the Remote Start Harness to the Factory Ignition Harness as shown.
D. Trim excess Wire Tie material.
N
O
T
E
Caution: Adjust the Remote Start Ignition Harness and Factory Ignition Harness as needed to make sure there are no rub, pinch areas or contact points with steering
column components and the tilt mechanism / springs as noted above.
Readjust the ties / harnesses if necessary to prevent contact.
9
Wire Cutters
Wire Ties
Factory Ignition
Harness
Remote Start
Harness
Remote Start
Harness
Check for clearances. Make sure
there is
no contact
between
harness and any metal parts.
Revision Date
5/03/2018
Page 6 of 11
