Genuine Accessories
Ensure that each Connector is fully seated in the Control Module and in
the Antenna.
Ensure the Control Module Assembly is fully seated on the Factory
Harness
Clean Cloth and 50/50 Mix of Isopropyl Alcohol (70%) and Water
Ratchet, 10mm Deep Socket, Extension, and Torque Wrench
Ensure the surface is completely dry before installing the Warning Label.
Ensure the label is aligned straight with the edge of the Radiator Cover
and without air bubbles under the label.
N
O
T
E
A. Connect the 20-Pin RES Connector (black) to the Control Module.
B. Connect the 4-Pin RES Connector (black) to the Control Module.
C. Verify the following:
- Antenna Bracket is attached to Control Module.
- Antenna is secured in bracket.
- Both black 6-Pin connectors are attached to Antenna and
Control Module.
N
O
T
E
A. Position the Control Module Assembly (Control A
Antenna H Antenna Bracket) behind the SJB, as shown.
B. Using two (2) Wire Ties, secure the Control Module Assembly
to left side of the Factory Harness as shown.
C. Trim excess Wire Tie material.
16
N
O
T
E
A. Clean the left top surface of the Radiator Cover.
- Ensure the surface is completely dry.
B. Remove the Adhesive Liner from the Warning Label, then secure
the label to the Radiator Cover as shown up against the raised front edge
of the cover.
A. Reconnect the Negative Battery Cable. Torque to:
5.0 ~ 6.0 N.m (0.5 ~ 0.6 kgf.m,
45 ~ 52 lb-in
).
B. Reinstall the vehicle's Negative (-) Battery Cover.
C. Reinstall the weatherstrip to allow Driver's Door to close properly.
D. Close the Hood, Tailgate and all Doors.
E. Test the LOCK / UNLOCK function using Factory Key Fob.
NOTE: If vehicle is not responding, carefully re-check all wiring
connections. If the vehicle is still not responding, follow the
Troubleshooting at the end of the instructions.
N
O
T
E
14
17
15
Wire Cutters
Black 6-Pin
Antenna
Connectors
Black 4-Pin
Connector
Black 20-Pin
Connector
Antenna
Control Module
Antenna
Bracket
Negative Battery
Cable
Negative Battery
Cover
Wire Ties
Control Module
Assembly
Factory
Harness
SJB
Wire Tie Mounting Holes
Feed wire tie through each
hole on Control Module and
tie to vehicle harness.
Remote Start
Harness
Warning Label
Revision Date
5/03/2018
Page 8 of 11