ENG
ENG - 29
14) TAPE BUTTONS
15) ANTENNA
16) HEADPHONE JACK
17) AUX-IN JACK
18) CD DOOR
19) HANDLE
20) USB PORT
21) AC SOCKET
START-UP OF THE DEVICE/INTRODUCTION
•
Select a suitable location for the device, such as a dry, flat, non-slip surface on which
it is easy to operate the machine.
•
Ensure that the device is sufficiently ventilated.
•
Remove the protective film from the display if it is still present.
POWER SUPPLY
•
Ensure that the voltage is the same as that indicated on the model identification plate.
•
Connect the power cable supplied (see battery compartment if necessary) to a properly
installed safety power socket and the mains connector AC on the back of the machine.
INSERTING THE BATTERIES(NOT SUPPLIED)
•
Open the lid of the battery compartment.
•
Insert 6 batteries of type UM-2 (“C” size) 1.5 V. Please ensure that the polarity is correct
(see the floor of the battery compartment)!
•
Then close the battery lid.
NOTE:
When a mains cable is connected the batteries are automatically switched off.
CAUTION:
•
Batteries can leak and lose battery acid. When not using the system for a long period
of time, remove the batteries.
•
Different battery types or new and used batteries must not be used together.
•
Do not dispose of batteries with household waste. Return old batteries to the respective
collection facilities or your dealer.
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the
like. Danger of explosion!
NOTE:
After about 10 minute without a signal, the device will automatically switch to standby.
Summary of Contents for TRC 333 AU3BT
Page 43: ......
