ENG - 42
RADIO OPERATION
AUTOMATIC TUNING
Press the “FUNCTION” button to select “TUNER” mode.
Press the “STOP / BAND” button to select AM or FM.
Press the “SKIP +” or “SKIP -” button to start automatic tuning process.
When a station is tuned in the tuning process, it will stop automatically and you can listen
to your desired station.
MANUAL TUNING
It is for selecting stations, which cannot be tuned automatically. (manual selection). To tune
a channel manually.
Skip step 4 in the above procedures.
In step 3, each time the “SKIP +” or “SKIP -” button is pressed momentarily (0.5 second
or less), the frequency changes by a fixed step:
FM: 0.05 MHz steps
AM: 9 kHz steps
MEMORY PRESET
Repeat step 1 to 4 in the AUTOMATIC TUNING procedures.
Press the “MEMO / ADJ.” button to start the preset process.
Display will show the memory sequence number and a flashing “1”.
Press the “P - UP” or “P - DOWN” button or the “MEMO / ADJ.” button of front panel to
determine the preset station number.
Press again the “MEMO / ADJ.” button to preset your desired station.
Once all the stations were preset, press the “P - UP” or “P-DOWN” button to listen to your
desired station.
MONO / STEREO
Press the “INFO MONO/ST.” button to achieve the best frequency.
FOR BETTER RECEPTION
Reorient the antenna for better reception.
Reorient the appliance to get better AM reception.
1)
2)
3)
4)
-
-
1)
2)
3)
4)
5)
6)
-
-
Summary of Contents for TRC 717 DR3
