ENG
ENG - 33
Motor thermostat
Important:
This motor is equipped with a motor protective thermostat. If for some reason the vacuum cleaner
should overheat, the thermostat will automatically turn the unit off. Should this occur unplug the
vacuum cleaner from the wall outlet and turn off switch. Remover dust cup and empty
Clean dust cup filter. Allow the unit to cool for approximately 45 minutes. To restart, replug into wall
outlet and turn switch back on.
Cleaning and maintenance
Always remove the power plug from the wall outlet before carrying out any maintenance.
If the suction power of your machine is getting lower, you must empty the dust container and clean
the HEPA filter. To do so, please follow the instruction below.
HOW TO EMPTy DUST CONTAINER AND REMOVE THE HEPA FILTER
You can easily see with the transparent dust container when it must be emptied.
1) Switch off the vacuum cleaner and disconnect the plug from the mains. To do this always pull
on the plug and not on the cable.
2) You can pull the dust container together with the cleaning system out of their anchoring with
the aid of the carrier handle on the dust container . Press button P10 (Fig.1) and lift out the
dust container and carry it to the waste bin (Fig.2).
3) A push button P12 is located on the dust container (Fig.3) that you can use to open and
empty it automatically (bottom-down technology). To do this hold the dust container over your
dustbin and press on the empty button.
4) Carefully turn the cover of the dust collector counterclockwise to release the collector. Remove
the HEPA filter by turning it counterclockwise (Fig.4). Clean the filtr according to the cleaning
instructions found in the manual.
5) After this push the HEPA filter cleaning system back into position in the vacuum cleaner until
it snaps into place. Your cyclone vacuum cleaner is now ready for use again.
Note:
When the dust container is full, it is sensible to pull a plastic bag over it and to empty it into this
bag. This prevents the spilling of dust.
Fig.1
Fig.2
