EN
EN - 23
To put filter on filter frame, pull and stretch the elastic edge of filter up and over the rim on the filter
frame.
Note:
If filter is not properly installed, dirt and dust will go past the filter and this can damage the
motor.
2. Clean the ventilation filter
Keep the ventilation holes free of objects and keep it unblocked.
Keep the filter dry before reinstalling it into the vacuum. Wet filter may cause the vacuum
cleaner to become damaged or cause personal injury!
3. Clean brush roll
The brush roll turns to sweep and comb the carpet nap. Keep the brush roll free from hair and
threads so it will continue cleaning.
Note:
Turn off the power and unplug the cord before doing the daily maintenance.
Troubleshooting
Problem
Possible Cause
Solution
Motor will not start
a) Electric plug
b) Check power switch
a) 1. Push plug securely into
outlet.
2. Try another outlet.
3. Check circuit breaker (fuse).
b) Make sure power switch is
on.
Does not clean the carpet or
floor
a) Dust cup and filter
b) Brush Roll
a) 1. Empty the dust cup
and clean or replace the
filter.
Hint: If pick up fine dust, the
dust cup may not look full
but a fine substance tends
to reduce suction when it
blocks the airflow through
the filter.
2. Be sure dust cup is pro
perly installed in Hand Vac.
b) Clean hair and thread
from bristles and end cap
area. Replace brush-roll is
bristles are worn.
Summary of Contents for VC 010S Flamenco
