EN
EN - 11
2. POWERING ON
Open the battery compartment cover and insert 2 x AAA batteries according to the correct
polarity showed in the compartment. After powering on, the clock will take about 3 minute
to connect with the outdoor transmitter. After that, it will start search radio signal. It will stop
searching signal till successfully received or 7 minutes later.
3. REMOTE FREQUENCY FUNCTION
The clock will take about 3 minutes to receive the temperature from outdoor transmitter once
powering on or resetting. Keep pressing ‘CH’ button for seconds to clear up the temperature
which received previously and it will start connecting with outdoor transmitter again. When the
clock is receiving the data from the outdoor transmitter, the signal will flash.
The clock will not search for the signal from outdoor transmitter if there is no signal received
from outdoor transmitter in 3 channels after powering on or resetting.
The clock will not search for the signal from outdoor transmitter anymore if there is no signal
received in 1 hour. It will display ‘---‘.
Wireless Outdoor Sensor: 433,92 MHz RF transmitting frequency; ERP: 0,05 mW
4. RADIO SIGNAL SEARCH
RC signal searching condition:
The clock will start search the signal automatically after transmitter connecting with clock when
powering on or resetting. Under normal time displaying mode, keep pressing ‘DOWN’ button to
enter into RC signal searching. RC signal searching will start everyday automatically and it will
last about 10 minutes. Automatically search radio signal to adjust time at 1:00 am, 2:00 am, 3:00
am, 4:00 am and 5:00 am. If there is no signal received or before 3:00 am, it will automatically
start searching at 4:00 am and 5:00 am. If signal received at 4:00 am, it will not search signal
that day. No matter the signal received at 5:00 am or not, there will not search again that day.
RC time searching will last 10 minutes.
RCC Receiving Icon:
When the clock is searching signal, RC icon
will be flashing.
After signal successfully received, LCD will display completed RC icon
which will stop
flashing, and existing RC searching.
Under the searching mode, press ‘DOWN’ button to exist RC searching.
If no signal received that day, next searching time will be at 1:00 am next day.
If alarm rings while searching RC signal, the clock will continue searching RC signal.
When receive DST, the DST symbol will display on the LCD screen
Manual TIME SETTING
At normal time displaying mode, keep pressing ‘SET’ button for seconds till entering time setting
mode, and the setting digit will flash. Press ‘UP’ or ‘DOWN’ button to adjust. The setting order
is 12 / 24hr
time zone
hour
minute
year
month
date
exit. If there is no more
operation for 20 seconds, it will save the existing setting and turn to normal displaying or press
‘SET’ button again to confirm the setting.
ALARM AND SNOOZE SETTING
At normal time displaying mode, press ‘ALARM’ button once to check the alarm time. Hold
pressing ‘ALARM’ button to enter the alarm setting mode, the setting digit will flash. Press ‘UP’
and ‘DOWN’ button to adjust, press ‘ALARM’ button again to confirm the setting. The setting
order is hour
minute
exit. If there is no more operation for 30 seconds, it will save the
existing setting and turn to normal displaying.
At the mode of alarm, press’ ALARM’ button once to turn on the alarm function and the signal of
is showed on the screen. Press ‘ALARM’ button again to turn off the alarm function.
The alarm sound will last for 2 minutes and it will change as below:
