EN
EN - 31
(5) Outdoor Temperature Alert Function
•
Press “ALERT” button (B7) to select to activate or deactivate outdoor temperature alert function.
•
Press ALERT button select to:
Active outdoor upper temperature alert, the icon “ ” besides outdoor temperature digit would
display.
Active outdoor upper& lower temperature alert, the icon “ ” besides outdoor temperature digit
would display.
Active outdoor lower temperature alert, the icon “ “ besides outdoor temperature digit would
display.
Deactivate outdoor temperature alert, alert icon disappear.
•
Hold “ALERT” button (B7) for 3 seconds to enter outdoor temperature alert setting. Icon “ ” or
“ ” beside Temperature’s digits flash. Press “+” or “−” button to adjust the setting value, press
“MODE” (B2) to confirm the setting. Setting Sequence as follow: Upper limit of temperature,
Lower limit of Temperature.
•
When it’s alert, the corresponding icon “ ” or “ ” and temperature digit would flash on the LCD.
Press any buttons to stop the alert sound, otherwise, it will sound for 2 minutes, and stop
automatically.
(6) Comfort Indicator Bar
(A6) for the display of pleasant / unpleasant climate.
(7) The use of 1.5 m cord Temperature Probe:
•
Insert the probe plug (D8) to the jack on the right hand side of the Thermo Sensor Unit.
•
Put the cable outside and leave the Thermo Sensor Unit indoor to avoid freezing up the battery
when the outdoor temperature is below −20 °C.
•
Always use the temperature probe to sense the temperature when the temperature is between
the following range: −50 °C ~ 0 °C and +50 °C ~ +70 °C
8. TIME AND ALARM SETTING
8.1 Radio Controlled Clock:
•
After batteries inserted and main unit finishes receiving the transmission from outdoor sensor,
the clock automatically starts to scan the DCF time signal.
Radio Control Icon “ “ flashes on the LCD.
flashes
Indicating now is receiving
DCF signal
turns on
Indicating signal received
successfully
disappear
Indicating signal reception
failed
•
The clock automatically scans the time signal at 3.00 a.m. every day to maintain accurate
timing. If reception fail, scanning stops (“ “ on LCD disappear) and repeats again at 4.00 a.m.
5.00 a.m. and 6.00 a.m.
•
The clock can be set to scan the time signal manually by holding “+”& “−” buttons (B4 & B5)
for 3 seconds. Each reception takes about 5 minutes. If receptions fail, scanning stops. (“ “
on LCD disappear) and repeats again on next full hour. E.g. scanning failed at 8.20a.m. It will
scan again at 9.00 a.m.
•
Stop scanning by holding “+”& “−” buttons (B4 & B5) for 3 seconds.
•
“
“ shown on the LCD if it is in Daylight Saving Time Mode.
