ENG
ENG - 59
DISPLAy BACKLIGHT
Press MODE/SNOOZE/LIGHT for an extended backlight.
LOW BATTERy INDICATION
Low battery indication is available for the main unit, USB transmitter & remote sensor. Replace
the batteries and follow the setup procedure in this instruction manual.
Low battery indicator
Main unit:
Below the “IN” icon
USB transmitter:
Below the “Last Update” box
Remote thermo sensor:
Next to the “CH 1 2 3” icons
IMPORTANT NOTE:
After battery replacement, you are required to set up the RF connection again.
Main Unit & USB Transmitter:
Press [PC Search] on main unit, then press [TRANSMIT] on
USB transmitter.
Main Unit & Remote Sensor:
Hold [CH/SEARCH] on main unit, then press [TRANSMIT] on
remote sensor.
USB TRANSMITTER
Press [PC Search] on the main unit and then press [TRANSMIT] on the USB transmitter to en
-
force transmitting RF weather data and set up the RF connection with the main unit.
(See “USB TRANSMITTER & PROGRAM INSTALLATION” section to set up the USB
transmitter).
USB transmitter comes with a blue light bar. You may disable or enable the continuous light bar
function by holding the [TRANSMIT] button on the USB transmitter.
NOTE:
To run the PC program, ensure that your USB transmitter is connected properly to the PC via
an USB port.
When weather data is transmitted from the USB transmitter, the light bar will flash.
-
-
Summary of Contents for WS2094 INTERNET
Page 69: ...Pozn mky Notatka Notes...
Page 70: ...Pozn mky Notatka Notes...
Page 71: ...Pozn mky Notatka Notes...
Page 72: ......
