EN - 36
3. OUTDOOR THERMO SENSOR
D1: Transmission Indication LED
D2: Battery Compartment
D3: Wall Mount Hole
D4: “RESET” button
D5: Channel Select Switch
D6: Temperature Probe Plug & Jack
D7: Stand
4.GETTING STARTED:
4.1 Main Unit:
• Slide open main unit battery compartment cover [C2]
• Insert 2 x AA batteries observing polarity [ “+” and “–” marks]
• Replace main unit battery compartment cover [C2]
• Use a pin to press the RESET [B7] button on the rear of the main unit, the main unit is now
ready for use
4.2 Outdoor Thermo Sensor
• Batteries compartment (D3) of thermo sensor is locating behind the back cover, unscrews
the batteries cover to open.
• Insert 2 x AAA batteries observing polarity [ “+” and “–” marks]
5. INSTALLATION
5.1 Main Unit
The main unit can be placed onto any flat surface (C3), or wall mounted by the hanging hole (C1)
at the back of the unit.
5.2 Outdoor Thermo sensor
The remote sensor should be securely mounted onto a horizontal surface.
Note:
Transmissions between receiver and transmitter can reach up to 30 m in open area.
Open Area: there are no interfering obstacles such as buildings, trees, vehicles, high voltage
lines, etc.