New R-Line Refuse Collection Micro
User Manual RCM10
23
3.8
Safety devices
Introduction
This machine is fitted with safety devices (illustrated below) to protect both
the operators and the machine itself:
1) Emergency stop buttons;
2) Hydraulic cylinders for lifting the bins and tank, fitted with double-
acting stop valves that block the cylinders in the position they are in
when the hydraulic pressure fails;
3) Hydraulic cylinders for lifting the hatch, fitted with double-acting
stop valves that block the cylinders in the position they are in
when the hydraulic pressure fails;
4) Fixed protection devices;
5) Hatch closure safety latches;
6) Rear edge closure control micro switch;
The diagram in figure 3-3 shows the positioning of the safety devices
installed on the machine.
Safety regulations
ATTENTION
It is absolutely forbidden to tamper with the safety devices, or
remove them. Hyva declines all liability for any damage to
persons, animals, property or the machine itself resulting from
the failure to observe this warning.
Fig.3 - 2
