New R-Line Refuse Collection Micro
User Manual RCM10
26
3.11
Description of the command and control equipment
Introduction
This section identifies and describes the commands on the machine; there is
also a description of the signals supplied by the command system to inform
the operator about the current machine operating status.
Layout of the command
and control equipment
A map showing the positioning of the command and control devices on the
machine is given below.
1) Command panel (inside the driving cab);
NOTE
Reference (1), illustrated in figure 3-5, shows one of the possible
configurations of the command panel inside the driving cab.
2) Two-handed control for closing the rear door;
3) Container emptying commands and compactor commands;
4) Emergency stop buttons;
5) Manual compacting shovel movement controls;
Fig.3 - 4
