® Waves System
V 1.1 - 2009
I.D. AL - EventPlayer MP3/Wav/DMX player - User manual
The show sequences are created on a computer using the ID-AL "Show Control Editor" software. The
event files created by the software are then copied into a memory card to be read by the player the same
way as audio files.
Power supply:
2 power supply sockets are available at the rear side of the player. The 2 sockets are
wired in parallel. This means that the power supply unit can be connected on any one of the 2 sockets
indifferently. The second socket helps to carry over the incoming power supply to a second EventPlayer,
sensors or any other device using the same voltage. The player is protected against polarity reversals
and against usage by mistake of an alternative power supply instead of the D.C. power supply.
Caution! The player can bear a tolerance of the power supply voltage between 10 & 15V. Beyond this
voltage range, the player can be damaged.
The power output of the amplifier depends on the mains power. When the line output is used, a power
supply of 500mA (6W) is sufficient to operate the player. When the amplified output is used, a
power supply unit of at least 3.45A (45W) is essential. If an inadequate power supply unit is used, there
is a risk of obtaining very poor sound and of overheating PSU leading to a break-down.
- 5 -
