® Waves System
V 1.0 - 2008
I.D. AL - GeoPlayer - MP3 and WAV Player with GPS function - Manual
1 - Speaker Output: The GeoPlayer includes a built-in amplifier. The board can therefore be connected
directly onto speakers. Connect the speaker wires onto the output of each of the 2 channels.
Caution: Never connect outputs between themselves, do not create short-circuits and do not use
speakers with lower impedance than specified in the player specification.
2 - Audio Output: on the line level stereo output, connect an amplifier, sound system, mixer or any
device providing a line level input. The 4 pins connector offers an internal connection link.
3 - Luminous indicator: a red LED displays the status of the player
- LED on permanently: no playback, GPS connected
- LED on and flashing twice: no playback, GPS non connected
- LED flashes regularly: reading, GPS connected
- LED off and flashing twice: reading, GPS non connected
- LED flashing slowly: Error signal (SD card problem... )
4 + 8 - Power supply: If the player is powered with a filtered and regulated power supply unit or a
battery, the recommanded tension is 12V DC, even if the player can be powered between 10V and 15V.
The current used will depend on the power of the amplifier.
Connector DC 2.1mm/5.5mm - + in the centre.
Connect a PSU or a 12V battery - The 2 pins
connector allows internal supply when the
board is integrated. Diode protection against
polarity
reversal
5 - Infrared: The GeoPlayer can be controlled with a infrared remote
handset (not supplied with the OEM board - available as an option).
- 6 -
Left speaker
Right speaker
Left output
Ground
Ground
Right output
Stereo audio output on mini-jack 3.5
Power supply
12V - DC
-
+
