® Waves System
V 1.0 - 2013
I.D. AL - MicroPlayer mkII - Wav MP3 Audio player - User manual
●
●
●
●
●
[Jxxx]
designates the folder number to use after reading the current file.
By adding this parameter within the file name, you define the conduct of the player at the end of the
reading of the current file in order to read another file.
If the destination folder does not exist, the action is ignored.
If the destination folder do not have any file , the player turns into stop mode.
Example:
My file [J002].mp3 - Jumps to folder 002 after reading file.
003 [J023][RL02].mp3 - Jumps to folder 023 after reading file 003 and enable output2.
034 [J034].wav - Jumps to folder 034 after reading the file. It’s not a loop with the file 034 but a jump
to folder 034.
This function allows for example to survey a file in order that he is followed by a Jump.
Several files can designate the same directory of jump.
Example :
001[J100].mp3 – after the reading of the file 001, Jump into folder 100
002[J100].wav – After the reading of the file 002, Jump into the folder 100
●
●
●
●
●
[RLxy] enables or disables the 2 output contacts
Each file can activate output contacts directly without any additional programming.
You can switch on lights, run a motor or any other action according to the files read.
[RLxy]:x,y represent the 2 outputs (x= output 1 – y = output 2) and can be from 3 values
x or y = 0 : outputs are disabled
x or y = 1 : outputs are enabled all along the reading of the current file.
x or y = 2 : outputs are permanently enabled. Another instruction is needed to disable outputs.
Example :
My file [RL00].mp3 : read the mp3 file. Outputs are disabled
001[RL10].wav – Enable output 1 during the reading of the file 001.wav then go on the reading of the
following file with desactivating output 1.
Message[RL02].mp3 – Enable output 2 during the reading of the file then go on reading of the following
file without disabling output 2.
004[RL21].wav – Enable the two outputs during the reading of the file 004.wav then go on the reading
of the following file without disabling output 1 and with disabling output2.
Output contacts are switched at the beginning of the reading of the file and disabled at the end of the
file.
●
●
●
●
●
[NT] or [DT]
- This option defines the interruption mode of the file currently read .
If these options are registered in the file name, the file cannot be interrupted and instructions received
are ignored or executed at the end of the file.
Without this option, reading of the current file can be interrupted at any time by an external
action except if the option is included within the name of the file.
Example:
001 [NT].mp3 - The file can NOT be interrupted.
An action on one of the input contacts, through RS232 link or any other is ignored and the reading of
the current reading is not stopped. Caution! The action is not memorised and the triggering information
is lost.
- 15 -
