I.D. AL - VP100HDi - Interactive Full HD 1080p video player - User manual
® Waves System
V 1.03 - 2012
●
●
●
●
●
01111111b (7F) : Setting the ID of the player
The ID is defined by the byte of data as follows:
Values of data for byte 3 included between 1 and 127
00000001b (01h) : ID = 001
01111111b (7Fh) : ID = 127
Note : Any other value will be ignored
Example to change the ID of the player from 001 to 002 :
Byte 1: 10000001b (81h) : status byte, player number 1
Byte 2 : 01111111b (7Fh) : Setting the new ID of the player
Byte 3 : 00000010b (02h) : New ID of the player = 002
Note : If you don’t remember the ID of the player, use ID=000 in the status byte (broadcast) to change the
ID of the player.
9.2 - Transmission Control Protocol
The EventPlayer provides a mode of information transfer, information which comes in, goes out identically
(Daisy Chain)
Any information received on the Rx line is sent out as received on the line Tx. Several EventPlayers can
be linked by connecting the Tx output of the first one onto the Rx input of the next one and so on... Data
received by the first player on Rx are sent out on Tx and received on the Rx input of the next player in the
chain.
Note: if a large number of players are connected this way, a slight delay may occur at the end of the chain.
- 20 -