I.D. AL - VP100HDi - Interactive Full HD 1080p video player - User manual
® Waves System
V 1.03 - 2012
10.3 - Output contacts
The VP100HDi can enable output contacts to operate various devices. You can switch on lamps, relays,
motors … The output contacts are activated through folders.
The output contacts of the VP100HDi are opto-couplers (see diagram below). The power output is limited
(switching up to 60V/50mA max) and only low power devices can be controlled, LED or small relays. To
switch high power devices you must use an interface between the outputs and the device to be controlled
such as the ID-AL MicroSwitch.
Example with push buttons to
start directory 1 or 2
Example of input combination to
start directory 21
Example of external trigger
using SensoPad and power
supply of the player
Output schematic
Out.x
Note : V+ is voltage output from the main power
supply. With a 12V power supply, V+ will be 12V
out. Max output is 300mA.
- 22 -
Example of output to control LEDs and
a relay with an external power supply.
