I.D. AL - VP100HDi - Interactive Full HD 1080p video player - User manual
® Waves System
V 1.03 - 2012
3 - INSTALLATION
1
2
3
4
5
6
1 - USB Host connector to use a
USB flash memory or external hard
disk or all other media with «mass
storage» compatibility.
2 - SD connector to use a SD/
SDHC memory card.
3 - Infrared sensor
4 - Volume buttons
5 - Status LED (red = sleep, orange
= initialising, green = operationnal)
6 - Sleep / wake up
7 - Power supply input
8 - VGA output (analog)
9 - HDMI output (digital)
10 - Ethernet RJ45
11 - Analog stereo audio output
12 - RS232 link
13 - Trigger input
14 - Power sypply out
15 - Trigger output
- 5 -
4 - Operating mode
4.1 -First use
The VP100HDi is delivered with default parameters. You need to change some parameters for an optimal
use like video out resolution, Ethernet link, time and date ...
1 -Connect the VP100HDi to a display using HDMI or VGA out. Connect the power supply but don’t insert
a media (SD or USB). Status LED change from red to orange and green for about 1 minute. Main menu
is now displayed.
2 -With the remote control, select «Setup» and change the parameters you want. (see the Setup chapter)
Note : By default, the VP100HDi is set in Full HD output resolution (1920x1080). If your display is not
compatible with this resolution, you need to change the resolution. At this moment, may be, you can’t see
anything on the screen. Don’t worry, you can change dynamicaly the resolution using the «ACT» key on
the remote control.
7
8
9
10
11
12
13
14
15
