ida 812-1x MIO Operator’s Guide
Operation
-19-
The
PAR.DATA
indicator LED has 2 states which indicate the follow-
ing:
State
Indication
OFF
Parallel interface inactive.
ON
Parallel interface active.
4.2. The TEST Key
As previously mentioned, tests are primarily selected via the line.
However, the
[TEST]
key may be used to activate the following:
•
Test 4, Setup printout
followed by
•
Test 1, ONLINE HEX dump.
An examples of the Setup printout obtained by activating the tests
can be found in
Chapter 10, Test Settings Printout
.
4.3. Printer Sharing
On the
ida 812-1x MIO
it is possible to use parallel output from an
IBM PC, as the printer interface contains a printer sharing module.
For both the twinax port and the parallel port, you can program a
user string to be used for initialisation in a share situation. This
string is defined via FSL Function 100 "Port Sharing Option", where
a timeout is specified (See
Chapter 7.
and
Appendix A
. for further
details on FSL functions).
1
The printer sharing module may be in one of two states:
•
Twinax session mode
•
Parallel session mode
When none of the modes are active, the twinax line will answer
READY
and the twinax and parallel lines are polled in turn.
If data is sent on the parallel line, the module will enter Parallel
Session mode. The twinax line will answer that the unit is
HOLD
.
1
Y100 for the parallel port is defined via Y246 (See Chapter 7. for further details).
