18
i-Go™
E
N
V. D I S A S S E M B LY / A S S E M B LY A N D
F O L D I N G / U N F O L D I N G
TILLER ADJUSTMENT
The tiller can be raised and lowered for folding, storage and
transport.
See fi gure 13.
1. Pull the tiller lever to disengage the pin locking the tiller in
place.
2. Hold tiller lever while adjusting height from folded height
to driving height.
3. Release tiller lever once locked into driving height.
For your convenience, the i-Go can be dissassembled for storage
and transport.
WARNING! Do not lift weight beyond your
physical capability. Ask for assistance when
needed while disassembling or assembling
your scooter.
NOTE: Prior to folding remove key, push circuit breaker toward
front of scooter, and check for any items left on the unit or in
the storage bin.
Figure 13. Tiller Adjustment
FOLDING/UNFOLDING
To fold your scooter (see fi gure 14):
1. Pull the locking pin to fold the seat back down onto the seat as shown in step 1.
2. Pull upward on the folded seat and squeeze the seat release to lower the seat to step 2.
3. While holding the main pivot handle, squeeze the tiller release handle and lift up on the main pivot handle while
guiding the tiller and front section of the scooter toward the folded/upright position shown in step 3.
4. Engage the front-to-rear latch to secure the front and rear sections of the scooter as shown in step 4.
5. Lower the tiller by pulling the tiller adjustment lever as shown in step 5.
To unfold your scooter (see fi gure 14):
1. Raise the tiller using the tiller adjustment lever to the driving position as shown in step 5.
2. Disengage the front-to-rear latch to unsecure the front and rear sections of the scooter as shown in step 4.
3. While holding the main pivot handle, squeeze the tiller release handle and guide it forward away from the rear
section of the scooter until it is in the driving position as shown in step 2.
4. Squeeze the seat release and then lift up on the seat until it is fully raised and in driving position as shown in step 2.
5. Pull the locking pin and unfold the seat back to an upright position as shown in step 1.
After unfolding your scooter:
1. Ensure that your scooter is in drive mode.
2. Install the battery if necessary.
See fi gure 10.
3. Push the circuit breaker toward the rear of the scooter.
4. Insert the key into the key switch and turn clockwise to start.
Summary of Contents for S20
