switching machine key initiative to terminate the call. After the call to the phone
number to send location information 1.5 format, the information in the status
prompt for the STATE: ANSWER. Non-stored phone numbers hang up
incoming calls directly without any treatment.
1.11
1.11
1.11
1.11 active
active
active
active help
help
help
help feature
feature
feature
feature
Function:
Function:
Function:
Function:
When you press the SOS button more than 3 seconds, then to three
phone numbers stored in 1.5 format to send location information, the
information in the status prompt for the STATE: SOS. And stored the first
phone call, if not turn the dial a second number, and so on.
(B)
(B)
(B)
(B) the
the
the
the application
application
application
application based
based
based
based on
on
on
on GPRS
GPRS
GPRS
GPRS
In this way, the terminal can be stored three numbers (1, 2, 3) and a 4-digit
password, a group of TCP / IP server IP address and port number, 4 digit GPS
code and a GPRS access point APN number. These groups of numbers
specified by AT commands or serial commands to set and change the text,
and for the non-volatile, even if the terminal is still valid after power-down.
2.0
2.0
2.0
2.0 Mode
Mode
Mode
Mode Switching
Switching
Switching
Switching
SMS
SMS
SMS
SMS command
command
command
command format:
format:
format:
format:
710 + user password
For
For
For
For example:
example:
example:
example: 7101234
7101234
7101234
7101234
Function:
Function:
Function:
Function:
When the terminal receiving the order, confirm the user password is
correct, it will switch to GPRS mode terminal, after the success of the sender
to send a confirmation to the
SET
SET
SET
SET MODE
MODE
MODE
MODE OK,
OK,
OK,
OK, CURRENT
CURRENT
CURRENT
CURRENT MODE:
MODE:
MODE:
MODE: GPRS.
GPRS.
GPRS.
GPRS.
Note:
Note:
Note:
Note:
This command set the next boot after the shutdown state is still in effect
until changed again received the relevant instructions.
2.1
2.1
2.1
2.1 Change
Change
Change
Change User
User
User
User Name
Name
Name
Name
SMS
SMS
SMS
SMS command
command
command
command format:
format:
format:
format:
# 801 # the user password the new user name # # #
For
For
For
For example:
example:
example:
example:
# 801 # 0000 # VSUN # #
Function:
Function:
Function:
Function:
When the terminal receiving the order, confirm the user password is
correct, the new user name to replace the existing user name, set up after the
success of confirmation to the sender to send a short message:
SET
SET
SET
SET SERVER
SERVER
SERVER
SERVER
USER
USER
USER
USER NAME
NAME
NAME
NAME OK.
OK.
OK.
OK.
