IDL707
(WIFI)
i.h.t Smart Lock User Manual
Please read this manual carefully before use
Information & Safety Warnings
1.
Required: Phillips screwdriver and 4 AA batteries.
2.
Keep your fingers clean before using this product.
3.
In original settings, the door can be unlocked with any fingerprint, any card, or the default
password ‘1234567890#’.
4.
To Unlock, press the registered fingerprint on the front handle sensor, tap card close to lock
pad, or enter password ending with ’#’.
5.
If the power is insufficient, there will be an alarm prompt. The lock can only be unlocked
around 50 times and then batteries need to be replaced. When power is low, connect to a
power bank with Micro USB line, using the Emergency Power Port to unlock. The App will be
offline in the meantime.
6.
Please do not use corrosive material to
clean
the surface.
7.
When you cannot unlock the door with password/fingerprint/card/APP, please use the key to
unlock the door. Please keep the emergency key with you or put it in outdoor safe place.
8.
Waking up the lock requires around 3 seconds, especially when it not been used in a while.
9.
The lock is suitable for 1.57-3.94 inch thick doors.
10. Outside of temperature Range: -22°C – 55°C.
Quick Setting
Adding the Administrator
1. Hold ‘*’ for 3 seconds or remove the battery cover, press 'Set'(back panel). The following voice
prompt will be heard: 'Please add administrator’.
2. Add administrator's fingerprint, card, or password.
a.
Fingerprint (3 Times)
i.
Place the fingerprint on the fingerprint induction area
ii.
Voice prompt ‘Please put the same fingerprint again’
iii.
Lift your finger and rest your fingerprint again
iv.
Voice prompt ‘Please put the same fingerprint again’
v.
Lift your finger and rest your fingerprint again for final verification
b.
Smart Card: Place the card to the key pad.
c.
Password (Twice)
i.
Insert the password ending with ‘#’
ii.
Voice prompt ‘Please input again’
iii.
Insert the password again ending with ‘#’
3. The following voice prompt will be heard: 'add successfully'.
Notes:
•
The first three registered users are administrator.
•
To improve fingerprint identification rate, adjust finger position accordingly.
•
‘*’: Back, Sign out button, '#': Confirm button.
