User Manual
BOP HD8 / BOP HD16
Ref.: IR1212828 A 21.08.2009
Edition 1.0
Page 23/87
I + M E A C T I A G m b H
3.1
A
SSEMBLY
Observe the following notes during selection of the mounting place of the BOP HD.
The BOP HD may not be directly exposed to climatic influence.
To prevent condensed water and excessive heat the mounting place must be
vented.
Ensure the access to connect peripherical devices, do maintenance and exchange
the data storage.
Avoid hard shocks and exceeding vibrations during the operation of the BOP HD.
To prevent damage to persons the BOP HD must be mounted safely. A loosening
by a crash must be impossible.
Unauthorised persons should not have access to the mounting place.
For the mounting the BOP HD, there are four drills with M6 thread at the lower side.
Drill the holes according to the drawing
Mount the BOP HD with four M6 screws. Please note that the screws may rise up to
the case at a maximum of 20mm. Use tension rings or tooth lock washers to safe
the screws.
Tighten screws hand tight.
See also chapter 8.3- Drawing IR11919 B
