24x10x40 CD-RW Drive
User’s Guide
- 13 -
Driver Installation
Windows 2000/Me/98/95 Installation
There is no need to install any CD-RW device driver under Windows
2000/Me/95/98/ and NT. After completing the hardware installation section
of this manual, please follow the steps below:
1
Turn on your PC to start-up your Windows 2000/Me/98/95 Operating System.
2
Windows 2000/Me/98/95 will automatically detect the new drive and
load the appropriate drivers for your CD-Rewritable drive.
Note:
Refer to the troubleshooting section of this manual if Windows
does not automatically detect your CD-Rewritable drive.
DOS or Windows 3.1x
Note:
Dos and Windows 3.X is not supported as a CD-Rewritable
drive. You can
“ONLY”
use it as a regular CD-ROM drive. Visit our
website for Dos / Windows 3.X drivers and information.
Windows NT 4.0 Installation
1
Power on your PC.
2
Log into Windows NT.
3
Once in the desktop, click on the “Start” button > “Settings” > “Control Panel” >
“Devices”.
4
Select "ATAPI" from the list and click on the "Start-up" button.
5
When you get the start-up screen, check "Boot" then click The "OK" button.
6
Repeat the same procedure with “CD-ROM” (steps 4 and 5).
7
Close the “Devices” screen and click on the “Start” button > “Shut Down” and
restart the computer.
Summary of Contents for 24X10X40
Page 1: ...24X10X40 CD RW Drive USER S GUIDE ...
Page 34: ...R CDRW241040 02 Ver 1 ...