I-PEX ISH, Instruction Manual

ISH INLINE CONNECTOR Instruction Manual

Document No. 

HDM-0006 

20

  / 

22

Confidential C                                                                                                                                                                                                   

9. Unmating of connector 

①

Hold the female connector and push it in lightly. 

②

While holding the female connector in, press down fully on the end of the arm (see Fig. 39). 

③

Keep pressing the lock down, and pull out the female connector. 

Notes 

①

Do not pull out the female connector without the lock arm fully pressed down.   
It may cause damage or deformation to the connector. 

②

Hold and pull the female connector (not the harness), when disengaging the connectors. 

③

If there is any damage or deformation, do not use the damaged item.   
Replace the item with a new one.   

④

Pressing down the front of the arm may not release the lock fully (see Fig. 40) 

Fig39. Lock arm 

③

Pull out female connector 

Direction of pressing 

②

Press down on the edge

Push point 

①

Push in lightly 

When the lock arm is pressed on the front part,   
center of the lock is bent. 

Fig40. Mechanism of the lock 

Press vertically with a thumb 

Good 

No good 

When the lock arm is pressed on the end, 
back portion of the lock is bent.