ISH HYBRID CONNECTOR Instruction Manual
Document No.
HDM-0009
14
/
24
Confidential C
5. Retainer installation
①
Make sure that both ends of the retainer protrude from bottom of the female housing surface before
inserting the female terminal into the female housing.
If one end or both ends of retainer are engaged with the female housing, pay attention not to
deform the female housing, and release the retainer by the method in 6(sheet 16).
②
Push the retainer perpendicularly to the female housing in order of [1]
⇒
[2] in Fig.28 after terminal insertion is complete.
(It is possible to insert it in the female housing at about 20N.)
You will hear audible click when the retainer is engaged properly.
③
Check that the retainer is pushed in completely, i.e. aligned with the bottom surface of the housing.
When the retainer cannot be pushed in completely, do not push forcefully. Check that the terminals are inserted correctly and
sufficiently, and repeat the insertion procedure in 4(sheet 13).
Insert all the terminals properly, and push the retainer until audible click is heard.
③
When terminals are insufficiently inserted as shown in Fig.29, the retainer cannot be installed.
Insert the terminals completely, and install the retainer again.
Notes
①
If there is any damage or deformation, do not use the damaged item.
Replace the item with a new one.
Fig 28.Installation of Retainer
Fig29.Insufficient retainer installation
Push in
Correctly
engaged
The retainer cannot be properly inserted because terminals interfere.
OK
No good
No good
No good
Fig.27. Checkpoint before engaging retainer and the female housing.
[1]
[2]
