I-PEX ISH20P, Instruction Manual

ISH HYBRID CONNECTOR Instruction Manual

Document No. 

HDM-0009 

18

  / 

24

Confidential C                                                                                                                                                                                                   

Notes 

①

Do not pry with the releasing jig or female terminals during operation. Check for any deformation or   
damage on the female terminals and the housing after releasing the femele terminals. (see Fig.36) 

②

Do not continue applying force once the lance has reached the ceiling, or the ceiling will be deformed 

    or releasing jig may be damaged by excessive force. Take sufficient care when handling.(see Fig.37) 

③

If there is any damage or deformation on the terminal or the housing, do not use the damaged item.   
Replace the item with a new one. 

④

Only use the terminal releasing jig specified. 

⑤

Do not insert the releasing jig into the cavities (see Fig.38) 
If the releasing jig is inserted into the cavities by mistake, the terminal may be damaged.   
Replace the terminal with a new terminal. 

⑥

Care must be taken not to damage edge of the jig (e.g. from dropping, etc.) 

⑦

Use appropriate jig to release terminal from the female housing. (see Fig.32) 

Fig 38. Incorrect insertion of the releasing jig 

Damage caused by releasing jig. 

Deformed ceiling 

Damaged releasing jig 

Excessive rotation 

Fig37.Deformed ceiling, Damaged releasing jig 

Fig36.Damage  caused  by  releasing  jig 

Cavity