ISH HYBRID CONNECTOR Instruction Manual
Document No.
HDM-0009
19
/
24
Confidential C
8. Rear cover installation (Rear cover : Individual part)
①
Verify that pin numbers of the female housing and the rear cover are the same and also the female housing corresponds to rear cover. In
addition, check that there is no damage, deform or dirt present.
※
There are two lock portions at right and left side respectively.
②
Check the directions of the female housing and the rear cover are correct.
③
Push the rear cover to female housing horizontally until the rear cover makes an audible click.
※
It is possible to install at 55N MAX.
※
It is possible to install the rear cover to the female housing which is either inserted or not inserted the terminals. When handling the terminal
inserted female housing, it should be careful not to catch the wire between the female housing and the rear cover.
④
Cannot remove the rear cover after installed one time.
※
Forcibly remove the female housing and the rear cover, it may result in damage.
※
Do not reuse the forcibly removed female housing and rear cover.
V0072-020B-111
V0072-020B-112
20 ISH CONNECTOR HYBRID 20P
V0072-93020-611
No. of
Poles
NAME
FEMALE CONNECTOR
PART NO.
REAR COVER
PART NO.
Table 5. REAR COVER
&
FEMALE HOUSING
Direction of installation
Fig 39.
Direction of installation
Fig 40. Installation of Rear cover
Engaging portion