NOVASTACK-B Instruction Manual
Document No.
HIM-16033
7
/
8
Confidential C
3-3.
コネクタ抜け止め荷重
/Press load
嵌合状態のコネクタ抜け止め荷重
(
筐体で押さえる荷重
)
につきましては、下記条件でコネクタ上面全体を
押さえる様にして下さい。
(抜け止め荷重:
20.0N
以下)
To prevent the coming off of the mated connectors (the load which a connector can apply),
press the entire upper surface of the connector with the load calculated in below formula.
(
Maximum Press load
:
20.0N or under
)
4.
挿抜方法
/ Mating and Unmating
挿抜はコネクタに対して水平に行って下さい。
過度なこじり及び回転を加えた挿抜はコネクタ破損の要因となりますので、行わないで下さい。
Always mate and unmate the connectors horizontally.
An excessive twisting or slanting when mating and unmating will damage the connectors.
※注意
1
/
Caution 1
挿入時の水平方向のこじり角度は、
10
°以下でお願い致します。
10
°以上での挿入は、コネクタ変形の原因となります。
Insertion angle shall not be slanted more than 10 degrees.
Slanted degree over 10 degrees may cause the deformation of the connector.
水平方向
/ Horizontally
奥行き方向
/ Side view
10
°
MAX