29
[Time]
Set the current time.
Step 3
Click the [Apply] button after setting the date & time.
→
The second will be set to "00".
[Set time zone]
Select your time zone.
GMT-12:00 - GMT+13:00
Default:
GMT
Marking the checkbox for [Activate the Daylight saving time
setting] will active daylight saving time.
Step 4
Click the [Next] button.
→
The camera registration window opens.
Note:
• To use the existing IP address of the connected cameras,
refer to "Detect cameras for registration [Detect cameras]"
(
☞
Operating Instructions (PDF)) instead of "Easy Start".
• Before the settings, register the cameras into the net-
work. Only the cameras added by license registration will
be detected even though more cameras than the regis-
tered license number are connected.
It is recommended to disconnect unnecessary cameras.
• Cameras shall be connected to the Camera/PC port.
Cameras will not be detected if they are connected to
the PC port.
Step 5
Register the cameras connected to the recorder.
The minimum settings required to operate the recorder, such as the date & time, camera registration, recording, can be config-
ured on the setup menu - the "Quick setup" menu - "Easy Start".
First, configure the minimum settings on "Easy Start", and to configure more advanced settings, go to each setup page.
Available settings on "Easy Start"
Step 1
Click the [Easy Start] button on the top screen of the
setup menu.
Refer to "Basic operations" (
☞
Page 7) for how to display
the setup menu.
→
The setup menu for the date & time will be displayed.
Step 2
Set the date & time.
[Date]
Set the current date. Select the year and month using the
buttons of the calendar and click the date.
[<<Y]/[Y>>] button:
Selects the previous or next year.
[<M]/[M>] button:
Selects the previous or next month.
• Date & time of the recorder
• Camera registration
• Order change of the registered camera numbers
• Recording frame rate, image quality and audio
* Other settings will remain default or will be conformed to the camera settings.
* To apply 25, 50 or 60 ips for the recording frame rate, configure on the advanced recording setup (for each camera) on the
"Recording setup" tab under "REC & event" of "Basic setup", but not on Easy Start.
* To reset the time, do not use "Easy Start", and go to "Basic setup" menu - "Date/Language" page.
7
Configure the minimum settings [Easy Start]
