3.8.6 Set the SCD areas [SCD area]
Set the areas to activate the SCD (scene change detection) function.
IMPORTANT
•
During change of setting in the setup menu, no alarm will be detected. After setup is complete, close
the setup menu.
1.
Set the SCD area by dragging the mouse on the screen.
→
The designated area will become the SCD area and the outline of white color will be displayed. The
“Status” will become “On”.
2.
Adjust “Detection area” and “Detection sensitivity” selecting the pull-down menu.
Refer to “3.8.5 Configure the SCD settings [SCD area]” for further information about the “Detection
sensitivity” and “Detection area”.
Change areas and the settings of “Detection area” and “Detection sensitivity” as necessary.
3.
Click the [Set] button after completing the settings.
IMPORTANT
•
The setting will not be applied unless the [Set] button is clicked.
4.
To invalidate the SCD area, click the [Set] button after selecting “Off” for “Status”.
→
The outline of the invalidated SCD area will turn to a dotted line. When the SCD area is invalidated, no
alarm will occur even when a motion can be recognized in the area.
5.
To delete the SCD area, click the [Delete] button.
→
The outline of the SCD area will disappear.
6.
Click the [Set] button.
→
The edited settings will be applied.
116
Operating Instructions
3 Detailed Settings
