20, 21, 22, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 443, 995, 10669, 10670
[Retry times]
Select a retry time for the TCP alarm notification.
•
Available range:
0-30
•
Default:
2
Destination of notification
[Address 1] - [Address 8]
Enter the destination IP address or host name of the TCP alarm notification from the following. Up to 8
destination server addresses can be registered.
•
[Alarm] checkbox:
When the checkbox is checked, the TCP alarm notification will be provided upon an
alarm occurrence.
•
[Diag.] checkbox:
When the checkbox is checked, notification using TCP alarm notification will be
provided in the following cases.
–
When notification of the remaining capacity of the SD memory card has been provided
–
When the SD memory card has become full
–
When the SD memory card cannot be recognized
–
When an SD memory card write error occurred
–
When deviation is detected when registering the initial angle of view, and when the deviation is
corrected
–
When the trial period for the extension software ends
•
[Destination server address]:
Enter the destination server address or host name.
–
Available characters:
Alphanumeric characters, the colon (:), the period (.), the underscore (_), and
the hyphen (-).
To delete the registered destination server address, click the [Delete] button respective to the desired
destination server address.
[Notification per VMD area]
Select “On” or “Off” to determine whether or not to set “Notification per VMD area”.
If “Notification per VMD area” is turned “On”, an alarm is notified only when “Alarm area No.” matches “Alarm
area” configured by “VMD alarm”. Alarm notifications other than “VMD alarm” are not implemented. When
using “Notification per VMD area”, select “On” for “Status” of the alarm area in VMD.
•
Default:
Off
[Alarm area No.]
•
Available range:
1-4
•
Default:
1
IMPORTANT
•
When entering the host name of the “Destination server address”, the DNS settings on the [Network]
tab of the “Network” page must be configured. (
®
“3.10.1 Configure the network settings [Network]”)
•
Confirm that the destination IP addresses are registered correctly. When a registered destination does
not exist, notification may be delayed.
Operating Instructions
119
3 Detailed Settings
