Note
•
To delete each certificate, set [IEEE 802.1X] to “Off”.
•
Check that the CA certificate and client certificate have not expired. If you use certificates that have
expired, you may not be able to use the port notification feature.
Example of CA Certificate check screen
Example of Client Certificate check screen
IMPORTANT
•
After selecting “On” for “IEEE 802.1X”, if access to the camera fails for some reason, connect to a
switch or port without authentication. It disables IEEE 802.1X, and enables access to the camera.
•
If the Client Certificate includes intermediate CA Certificate, the Client Certificate needs to come first,
then the intermediate CA Certificate.
•
When a certificate over 10 Kbyte is installed, no error will be displayed during installation. However,
an error may occur at the time of connection.
3.9.4 Configure the data encryption settings [Data encryption]
Click [Data encryption] on the “User mng.” page. (
®
For menu display and how to operate, refer to “3.2 Display
the setup menu from a PC”, “3.2.2 How to operate the setup menu”)
The settings relating to the data encryption can be configured in this section.
Click the “+” mark on the left of the setup menu to expand the respective item, and enable detailed settings.
Operating Instructions
127
3 Detailed Settings
