3.10 Configuring the network settings [Network]
The network settings can be configured on the “Network” page.
The “Network” page has the [Network] tab and the [Advanced] tab.
3.10.1 Configure the network settings [Network]
Click the [Network] tab on the “Network” page. (
®
“3.2.1 How to display the setup menu”, “3.2.2 How to operate
the setup menu”)
The following information is required to configure the network settings. Contact the network administrator or
your Internet service provider.
•
IP address
•
Subnet mask
•
Default gateway (when using the gateway server/router)
•
HTTP port
•
Primary DNS address, Secondary DNS address (when using DNS)
IPv4 network
[Network Settings]
Select the method of how to configure the IP address from the following.
•
Static:
The IP address is configured by entering manually on “IP address(IPv4)”.
•
DHCP:
The IP address is configured using the DHCP function. If the camera cannot acquire an IP address
from the DHCP server, set the IP address to “192.168.0.10”. After that, once an IP address is acquired
from the DHCP server, change it to that IP address.
•
Auto(AutoIP):
The IP address is configured using the DHCP function. When the DHCP server is not found,
the IP address is automatically configured.
•
Auto(Advanced):
Using the DHCP function, network address information is referred to, and an unused
IP address is configured to the camera as a static IP address. The configured IP address is automatically
determined within the subnet mask range by the camera. When the DHCP server is not found, the IP
address is set to 192.168.0.10.
•
Default:
DHCP
Note
•
When “Auto(AutoIP)” is selected and the IP address cannot be obtained from the DHCP server, an IP
address not used in the same network will be searched within 169.254.1.0 - 169.254.254.255.
[IP address(IPv4)]
When not using the DHCP function, enter the IP address of the camera. Do not enter an IP address already
in use (for the PCs and the other network cameras).
•
Default:
192.168.0.10
Note
•
Multiple IP addresses are unavailable even when using the DHCP function. Refer to the network
administrator for further information about the settings of the DHCP server.
[Subnet mask]
When not using the DHCP function, enter the subnet mask of the camera.
•
Default:
255.255.255.0
130
Operating Instructions
3 Detailed Settings
