Default:
Center of live image
Note
•
A red frame indicating the display position will be displayed during dragging of the uploaded image.
•
Coordinates that make the uploaded image out of the setting screen are unavailable to set.
•
When an uploaded image is moved by mouse operation, the display position will be saved even if the
[Set] button is not clicked.
•
If an uploaded image is moved to the edge of the screen, there may be a gap between the image and
the screen edge.
IMPORTANT
•
After changing the settings of [Image capture mode] or [Image rotation], check the display position of
the uploaded image. When the display position is deviated, configure the display position setting again.
If the uploaded image is to be displayed out of the setup screen, the initial display position (center of
the live image) will be restored.
[Permeation]
Select “On” or “Off” to determine whether the color selected at [Selection of color to be penetrated] is to be
transparent.
On:
Gives transparency to the color selected at [Selection of color to be penetrated].
Off:
Does not give transparency to the color.
Default:
Off
[Selection of color to be penetrated]
Select a color to be penetrated in the following procedure.
1) Click the [Color Selection] button. A sub window displaying the uploaded image will be displayed.
2) Click a color to be penetrated in the displayed image. The selected color and RGB values will be displayed.
3) Click the [Close] button to close the sub window.
4) Click the [Set] button lastly. The selected color will be penetrated.
Operating Instructions
79
3 Detailed Settings
