3.9 Configure the settings relating to the
authentication [User mng.]
The settings relating to the authentication such as users and PCs restrictions for accessing the camera with a
PC, mobile terminal or tablet device can be configured on the “User mng.” page.
The “User mng.” page has 4 tabs; the [User auth.] tab, the [Host auth.] tab, [IEEE 802.1X] tab and [Data
encryption] tab.
3.9.1 Configure the settings relating to the user authentication
[User auth.]
Click the [User auth.] tab on the “User mng.” page. (
®
“3.2.1 How to display the setup menu”, “3.2.2 How to
operate the setup menu”)
The settings relating to the authentication of users who can access this camera from the PC, mobile terminal
or tablet device can be configured on this page. Up to 24 users can be registered.
Note
•
When user authentication has failed to pass (authentication error) 8 times within 30 seconds using the
same IP address (PC), access to the unit will be denied for a while.
[User auth.]
Select “On” or “Off” to determine whether or not to authenticate the users.
•
Default:
On
[Guest User]
Select whether or not to set Guest User. If you select “Use”, you can set which functions are available or
unavailable for guest users for whom user authentication has not been performed.
•
Default:
Use
[Authentication]
Set the user authentication method.
•
Digest or Basic:
Uses “Digest or Basic” authentication.
•
Digest:
Uses “Digest” authentication.
•
Basic:
Uses “Basic” authentication.
•
Default:
Digest
Note
•
To enhance the security, it is recommended to select “Digest” for “Authentication method”. If “Digest
or Basic” or “Basic” is selected, leakage of the user name and the password may occur.
•
When the [Authentication] setting has been changed, close the web browser, and then access the
camera again.
•
About the system devices (our network disk recorder and others)
For the model No. and the firmware version of applicable products, refer to our technical information
website <Control No.: C0701>.
[User name registration]
At the time of new registration, register a new user name in [User name]. Click [
] in “User name
registration” to view registered users. Registered users are displayed as “Registered user name [Access
level]”. (Example: admin [1])
If you click the [Change] button on the right, the selected user will be displayed in [User name], and you can
change the password. By clicking the [Delete] button on the right, you can delete the selected user.
Operating Instructions
121
3 Detailed Settings
