•
When “On” is selected for “Additional info for detecting alteration”, the maximum value of the available
bit rate for “Stream” will be limited.
[Save trigger]
Select a trigger to save images on the SD memory card from the following.
•
SFTP periodic image transmission error:
Saves images when periodic image transmission to the SFTP
server fails. Available only for “JPEG(1)” and “JPEG(2)”.
•
Alarm input:
Saves images at an alarm occurrence.
•
Manual:
Saves images manually.
•
Schedule:
Saves images in accordance with the settings for “Schedule” (
®
relating to the schedules [Schedule]”). Available only for the “Stream(1)”, “Stream(2)”, “Stream(3)”, or
“Stream(4)” images.
•
Default:
Manual
If you have selected “Alarm input” in the [Save trigger], you can select the alarm type from the following:
•
VMD:
Save the image when motion detection occurs.
•
SCD:
Save the image when SCD occurs.
•
Command alarm:
Save the image when a command alarm is entered.
Note
•
If “Stream(1)”, “Stream(2)”, “Stream(3)”, or “Stream(4)” is selected for “Recording format”, “SFTP
periodic image transmission error” is unavailable.
•
To enable alarms to occur, alarm settings must be configured in advance on the [Alarm] tab.
•
When “JPEG(1)” or “JPEG(2)” is selected for “Recording format”, “Schedule” is unavailable.
•
When connected with our network disk recorder, “Save trigger” may be displayed in a gray-out state
as “Network failure”. To change the setting of “Save trigger” after disconnecting the recorder, set “Not
use” for “SD memory card” once and then set “Use” again.
•
Alarm recording is not available for streams that are being distributed in a state where
“Advanced(Fixed GOP 60s w/1s key-frame)” is selected for “GOP control”.
•
No image will be recorded at the time of an audio detection alarm occurrence.
JPEG recording(Manual)
This setting is only available when “JPEG(1)” or “JPEG(2)” is selected for “Recording format”, and “Manual” is
selected for “Save trigger”.
[File name]
Enter the file name used for the image to be saved on the SD memory card. The file name will be as follows.
•
File name:
[“Entered file name” + “Time and date (year/ month/ day/ hour/ minute/ second)”] + “Serial
number”
•
Available number of characters:
1 - 8 characters
•
Unavailable characters:
" & * / : ; < > ? \ |
[Image saving interval]
When “Manual” is selected for “Save trigger”, select an interval (frame rate) of saving images on the SD memory
card from the following.
–
When 30fps mode or 15fps mode is selected for [Image capture mode]:
0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps
Operating Instructions
71
3 Detailed Settings
