4
ENGLISH
INTRODUCTION
This document contains information and safety regulations which are to be observed without
fail for safe operation of the device
IS910.2
under the described conditions . Non-observa-
nce of this information and instructions can have serious consequences and/or may violate
regulations .
Please read the manual and these safety instructions before using the device . In case of any
doubt, the German version shall apply .
The current EU-declaration of conformity, certificates, safety instructions and manuals can be
found at
www.isafe-mobile.com
or requested from
i.safe MOBILE GmbH
.
RESERVATION
The content of this document is presented as it currently exists .
i.safe MOBILE GmbH
does
not provide any explicit or tacit guarantee for the accuracy or completeness of the content of
this document, including, but not restricted to, the tacit guarantee of market suitability or fit-
ness for a specific purpose unless applicable laws or court decisions make liability mandatory .
i.safe MOBILE GmbH
reserves the right to make changes to this document or to withdraw
it any time without prior notice . Changes, errors and misprints may not be used as a basis for
any claim for damages . All rights reserved .
i.safe MOBILE GmbH
cannot be held responsible for any data or other loss and direct or
indirect damages caused by any improper use of this device .
EX-SPECIFICATIONS
The device
IS910.2
is suitable for use in potentially explosive atmospheres classified (zone
2/22) in accordance with directives 2014/34/EU and 2014/53/EU, as well as the IECEx scheme .
EX-MARKINGS
ATEX:
II 3G Ex ic IIC T4 Gc IP64
II 3D Ex ic IIIC T135°C Dc IP64
EU Type Examination Certificate:
EPS 17 ATEX 1 123 X
CE-designation:
IECEx:
Ex ic IIC T4 Gc IP64
Ex ic IIIC T135 °C Dc IP64
IECEx Certificate: IECEx EPS 17 .0069X
Temperature range:
-20°C … +60°C
Manufactured by:
i.safe MOBILE GmbH
i_Park Tauberfranken 10
97922 Lauda-Koenigshofen
Germany
EU-DECLARATION OF CONFORMITY
The EU-declaration of conformity can be found at the end of this manual .
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it must