22
6
Operation
6.1
Before you start
ATTENTION
•
The i-cover® 2.5 can operate with only the blue coded battery, in this manual the
optional gray battery is also described.
•
Make sure that the batteries are fully charged before you start. Please refer to the
user manual of the i-charge® 2 or the i-charge® 9.
6.1.1
Inserting the batteries
1.
Open the battery holder (Figure 11, pos 2) at
the side of the i-cover 2.5.
2.
Place the blue coded battery in the blue
battery slot at the top (Figure 11, pos 3).
3.
Place the gray coded battery (option) in the
gray battery slot at the bottom
(Figure 11, pos 1).
4.
Close the battery holder (Figure 11, pos 2).
5.
Press the ON/OFF switch below the battery
holder to turn on the i-cover 2.5.
6.
Check the battery indicator next to the main
switch. See also section 2.1.
7.
Turn off the i-cover 2.5.
TIP:
It is not recommended to use the batteries when charged less than 40%. The i-cover 2.5 can
operate on a single battery.
Figure 11