32
6.4.4
Cleaning with water
ATTENTION
Make sure the spray gun is facing away from you during this action.
1.
Put the batteries in the machine (see 6.1.1).
2.
Pour some water in the fluid tank (see 6.1.2).
3.
Turn on the i-cover® 2.5 using the ON/OFF
switch (Figure 19, pos 3).
4.
Press the ON/OFF button (Figure 23, pos 2)
on the spray gun.
5.
Wait for 10-seconds, to allow some water to
come out to clean the nozzle.
6.
Press the ON/OFF button on the spay gun
(Figure 23, pos 2).
7.
Press the ON/OFF button on the body of
i-cover 2.5 (Figure 19, pos 3) to turn it off.
8.
Put the i-cover 2.5 on a table with the
backside towards you.
9.
Release the drainage tube (Figure 22, pos 1)
via the clips (Figure 22, pos 3).
10.
Open the tap (Figure 22, pos 2).
11.
Put the end of the drainage tube into a
proper container for disinfectants.
12.
When empty close the tap (Figure 22, pos 2).
13.
Replace the drainage tube (Figure 22, pos 1)
using clips (Figure 22, pos 3).
Figure 23
